![]() ![]() Not sure if this will help you but here are the notes I made for myself on how to add IKEA lamps to HA (I also use Proxmox and Conbee II). If I try to have them join the IKEA gateway again, it’s no problem - so I guess it’s not the lamps that have all gone faulty.Īm I missing something totally obvious here? The strange part is that this particular panel is the IKEA panel that’s located furthest away from the conbee (about 5 meters, but with two walls between), while there are 4 other FLOALT lamps that are much closer. The really strange thing, is that during my endless searching attempts, at one time it did find one single lamp - a FLOALT panel 30x90. To ensure that I’m not just having radio interferance from my wifi, I have turned off my wifi to see if it made any difference - it did not. When searching, I have the conbee placed directly on the lamp, but it just can’t wont my lamps. I have then reset all the IKEA lamps, (by power toggling), and connected them first to my old IKEA gateway, and updated the lamps to newest firmware, and then reset them again (to make sure they are ready to connect to conbee) As I can see the firmware version, I must assume that HA does indeed see the USB stick. I have upgraded the Conbee, and it’s now running firmware 26720700 as can be seen in Phoscon - the conbee is connected via a 1-2 meter USB cable. I do however find it very hard to get it to connect to the lamps (with a single exception). I’m running Home Assistant on a proxmox setup - and have set it up to enable USB passthrough.įor a couple of years I have been running some ikea floalt panels and some hue lamps on my philips hue gateway, and now I want to move over to run towards the ConBee II - I’m hoping to be able to first move the IKEA lamps, and then later the philips hue lamps. ![]() I have tried all the troubleshooting I have found so far, but I’m not able to get a proper result, so I’m hoping someone can point me in the right direction. I’m trying to setup the deconz and phoscon with the conbee II, but I’m having some problems.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |